Windows 10: Is there a way I can connect to WiFi via recovery command?

I can’t log in reset tpm as per standard protocol to reevaluate my computer and it would not let me connect to WiFi to reset my Microsoft account. Log in screen doesn’t even appear anymore. I did this before several times on my windows 10 laptop. But this 11 will not comply. Hardware and bios detect ipv4 and ipv6 but, I am unable to co figure WiFi setting via recovery command prompt. My cpu is the only one with the issue, my WiFi allows more devices but, not my laptop. No other CPU’s available. I input the following commands that work:Ipconfig /flushdnsSuccessfully flushedNetsh wlan>The fol

:)

 

Windows 10 - WIFI 2 - Cant connect

Hi
Myamara,

It is possible that your drivers are outdated or the connection itself has the issue. We suggest that you perform
these methods of troubleshooting
and check if there are any changes:

Method 1: Reset TCP/IP

To do this, follow these steps:

• 
  Run
  Command Prompt
  as
  Administrator.
  
• 
  Run
  this command:
  
  • 
    netsh int ip reset
    and hit
    Enter.
    

Exit
Command Prompt
and
monitor your WiFi connection.

Method 2: Disable auto turn-off of WiFi device.

Go to
Network and Sharing Center. At the
right pane, click
Change adapter settings.
Right-click
on your
connection name(WiFi name)
and go to
Properties.Click
the
"Configure..."
button and go to
Power Management
tab.Uncheck/disable
the
radio button
for
"Allow this device to turn off this device to save power". And then,
Restart the PC(Important).

Method 3: Reconfigure TCP/IP

To do this, follow these steps:

• 
  Run
  Command Prompt
  as
  Administrator.
  
• 
  Run
  these following commands:
  
  • 
    netsh int tcp set heuristics
    disabled
    
  • 
    netsh int tcp
    set global autotuninglevel=disabled
    
  • 
    netsh int tcp set global
    rss=enabled
    

Update us on how it goes.

Regards.

 

Is it possible to set up a new manual wifi connection from the command line?

I'm trying to work out a solution to set up ad-hock wifi connections in Windows 8.1 based on the suggestions in a post on Micsrosoft's answers site. Is there any way to do the first few steps:

• go to "Network and Sharing Center"
  
• click "Set up a new connection or network"
  
• double click "Manually connect to a wireless network"
  
• enter the SSID of the ad-hoc network (as shown by "netsh wlan show networks") into the "Network name" field
  
• configure security settings accordingly
  
• uncheck "Start this connection automatically" (important)
  

...without using the windows dialogs?

 

GPU-Z what command line parameter ?

Suggestion: /? (-?) and /help (-help) command-line arguments to show a list of all possible arguments in a small window. *Smile