Windows 10: Is there a way to skip connecting to a network during setup after fresh start? Network...

I've been having an issue with my network driver disappearing on my windows 11 laptop for about a week and have yet to find a permanent solution. The only thing that does work temporarily is uninstall/reinstall it then restart device. I'm having to do this several times a day, and it's beyond frustrating. I finally gave up and just did a full reset, fingers crossed that a fresh start would be the answer. But now i have another problem. After booting up on reset it disappeared again. As I'm choosing region, language, etc. Now I'm stuck here, no option to go back. I can't find anything regardi

:)

 

Losing network connection

Hello Dear, if you have a laptop or a PC with a wireless network adapter, you can see a list of available wireless networks and then connect to one of those networks. The wireless networks will only appear if your PC has a wireless network adapter installed, the adapter is turned on, and the wireless access point is in range.

1. Click Start, click Control Panel, click Network and Internet Connections, and then click Network Connections.

2. In the left pane, under Network Tasks, click View available wireless networks.
In case, If you don't see the network you want to connect to, click Refresh network list. If you see the network but the signal is weak, move the PC closer to the wireless router.

3. Click the network you want to connect to, and then click Connect.

4. If you're connecting to a secure network, type the security key, and then click OK.

I Hope you solve out your query soon.

 

No network connection

Hello Graham,

To resolve your concern about wireless network issues, please click the link below and follow the suggested troubleshooting steps:

• Fix network connection issues in Windows 10

Let us know how it goes.

 

PC wont connect to network.

I have a HP computer that is set off aside that I am going to use for folding and for some reason it wont connect to my network. I have the modem connected to a switch, and from there my computer and the HP is connected, but I can get a connection but not my HP comp. Now when I hit repair it says that it couldn't do anything because it stops at IP renewing. I have even went into networking and changed the network connection to the top of the list.

See I hit repair and it says that it is renewing the IP address but it doesn't, then error.

How can I get it connected to my internet?