Windows 10: It just stopped during format, what should I do? Reset or wait?

submitted by /u/mkkaczm
[link] [comments]

:)

 

Changing Time Format

Hi Mary,

There's a possibility that the set up time format in your computer Basic Input/Output System (BIOS) is military time. To have this checked, you can try to reset the time of your computer through Control Panel. See the steps below on how to do
so:

• Open Control Panel > Clock, Language, and Region >
  Change date, time, or number formats. This would open the
  Region window.
• From there, click on Additional settings at the bottom part. It will open the Customize Format.
• Click Reset; then, OK.

The steps should work; however, if not, we suggest that you contact manufacturer and have the BIOS time checked.

Let us know what happens after doing the suggestions .

 

What PSU should i get?

I find NO specs on the psu you listed, not the one ktr listed, ktr also suggested i get the mushkin psu!

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!