Windows 10: It seems that Windows is asking for device drivers that do not appear a problem in the VM...

Virtualbox installs windows, whereas bare metal doesn't. What might I need to install it?

:)

 

Taskbar bug: switching to another window -will not appear at the front


Follow either of these steps to fix the issue with the Active window hiding behind.

Method 1:
I suggest you to disable window by hovering over it with the mouse and check if it helps. To do so I suggest you to try the below given steps and check if it helps:

1. Press Windows key + X key and click on Control Panel.
2. Select or click Ease of Access.
3. Click or tap onEase of Access Centre.
4. Click on Make the Mouse Easier to Use was uncheck Activate Window by hovering over it with the mouse.
5. Check if issue is resolved.

Method 2:
I would suggest you to completely uninstall the touchpad driver and reinstall it. Kindly follow the below given steps.

1. Press “Windows key + X” and click on “Device Manager”.
2. In the list of devices, you should see the touchpad drivers.
3. Right click on the device and then select "Uninstall".
4. In the uninstall dialog, make sure you select the option to delete the driver package from the system. This causes the driver package installed earlier to be deleted.
5. In the Action menu of Device manager, select “Scan for Hardware changes” option. This will cause the device driver to be reinstalled. Once the driver is installed, close all windows and restart the computer.

 

Taskbar bug: switching to another window -will not appear at the front


I have been trying to fix this for months. Your solution Method 1 seemed to work. THANK YOU!!!!

 

Windows 7 Asus M2A-VM Raid Drivers

I understand what a .exe file does but it needs to load as a driver at the beginning of the windows installation. Windows needs the right driver so that raid 0 will work. I have a diploma in Computer Systems at a recognized college so I am not an idiot. I picked up my hardware manual and I am doing this right. I will describe my steps:

- 2 x HDD's plugged into slot 1 and 2 (color coded) and unplugged 500gig HDD (slot 3)
- enter BIOS, set SATA/RAID enabled
- save and exit BIOS
- restarts, ctrl-F to enter raid controller
- create raid array 0 by deleting logical drives and create a new array
- ctrl-F utility recognizes the raid 0 configuration
*** These steps above work wonderfully for windows XP and Vista raid 0. I had the right drivers, and it loaded just fine.
- Enter Windows RC 1 setup
- new custom install option
- no HDD's listed at all (because no drivers are loaded for RAID)
- "Load Driver" button - selected your 32-bit link .exe driver. "driver no found"
*** I confirmed in windows that the .exe is in the disk and I did a data check after burning it without a problem
*** The load driver button works wonderfully in XP and Vista for raid 0, that rules out everything but a faulty driver.

I was kind of disappointed that the .exe did not work. This isn't rocket science. I say it is the driver. Any assistance is appreciated!