Windows 10: IVAP Interface connection

IvAp-User Interface Connection to the IvAp Network Interface has been lost. We will try to reconnect to the Network Interface, check if the Network Interface is running on the correct machine.I tested the procedure proposed by Bianca B14 but the problem persists.Could this be due to W10 updates?Thanks for your help Reda Sahnine * Moved from Community Center

:)

 

W10 can connect to wider internet but cannot access web pages

I have an odd issue with my W10 laptop linked to Sky broadband in the UK via wifi using a Sky router. The effect is that while I can actually access the internet (I can send and receive emails using Outlook and can connect to other machines using TeamViewer) I cannot access any web site (Google, BBC etc). There is no specific error message, merely that the access request timed out and a suggestion that it may be to do with proxy.

I have tried the following:

1. Other systems (W10 and ios) can access web sites using the same Sky router (therefore probably not a router problem)
2. I have sent and received emails using Outlook, so the broadband connection is working (probably not a Sky problem)
3. I have tried two different browsers (Firefox and Edge), no connection (not a browser problem)
4. I am using Windows Defender and have:
   1. Made sure that Firefox is in the list of allowed systems in its Firewall, no connection after a reboot
   2. Turned off the Firewall and tried again - no connection

My next step will be to re-install Windows, but has anyone got any other suggestions? Could it be some sort of virus (I have carried out a complete virus check using Defender)

So - any suggestions?

 

A bunch of "ghost" wired connections.

Hi,



Use these commands in command prompt to delete the profiles.

Follow the steps:

• Press Windows Key + X.
• Select Command prompt(admin).
• Type the following command:

delete profile interface="Local Area Connection"

delete profile interface=L*

For more information, I would suggest you to refer to this section 'delete profile' in the article provided.

Netsh Commands for Wired Local Area Network (LAN) in Windows Server 2008 and Windows Server 2008 R2 | Microsoft Learn

Note: This article also applies to Windows 10.

Hope it helps.

 

Multichannel audio interface in/out routing

Hi Paulo,



Thank you for writing to Microsoft Community forums.

• What is the make and model of your external audio interface?
• Which routing application are you using?

The configurations of inputs and outputs on any audio interface is dependent on the hardware and its supporting software. Any audio interface with more than 2 inputs and 2 outputs, should ideally give the user an option to map the
Input and Output Config, according to his interest.



I suggest you to go through the user manual provided by your audio interface's manufacturer to know how to set up the control surface.



If it doesn't explain how to configure, I suggest you to get in touch with the audio interface's manufacturer to know how to configure the same.



Hope it answers.

Regards,