Windows 10: Kaspersky S.M.A.R.T. check says my hard drive is at 0% health, but Command Prompt says it...

Does anyone know what could have caused the discrepency?


For context, I have an HP laptop, with a 256GB SSD hard drive. I bought it professionally refurbished online 2 years ago.

It originally had a 128GB SSD hard drive, but I paid extra for it to be updated. It runs Windows 10.

:)

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that

 

command prompt will not open in safe mode with command prompt

Would I just follow the same steps within safe mode after hooking up to the other system?

 

command prompt is x:\windows\system32

My computer crashed and I have tried everything I can think of you restart, but the command prompt starts with x: instead of c: I've tried the fixes suggested and listed below:

In Command Prompt, type DISKPART, press Enter.

When it loads type LIST DISK.

Choose the Windows hard drive by typing SEL DISK # with # being the desired disk number from results.

Then type LIST VOL which will provide a list of the various partitions with their assigned drive letters in Recovery mode which may be different than in Windows.

But when I type in DISKPART is says There are no disks to show

Any ideas?