Windows 10: KB5035853 Has broken multi-monitor support and charging in my laptop

After KB5035853 was installed on my thinkpad x1 carbon gen 9 laptop, the charging stopped working and usb3 to hdmi support broke. I thought this was some hardware failure, but tried to revert the update first. Attempting to revert this update by windows restore bricked my windows installation. Booting the system using live cd to recover my files revealed that the hardware was fine, it was purely a system issue. I am now restoring the system using the restore drive.

:)

 

Toshiba Laptop Not Holding Battery Charge

attached is a pic of the internal of the laptop there does NOT appear to be a CMOS battery what should my next steps be? - fully charge existing battery and see if i remove it and install back teh next day whether its still fully charged? - charge the battery for 18 hours to charge the internal CMOS battery? - suggestions please as Im not sure

 

Laptop no longer charging since Windows 10 update

If the laptop works without the battery then charger is functioning correctly. Take a cloth with a bit of rubbing alcohol on it (or some on-the-go alcohol swabs), and clean the metal contacts that connect your battery to your laptop.

Make sure to install all Windows important updates.

Install latest versions of your laptop device drivers you can download the latest device drivers from the device manufacturer or from your laptop manufacturer website.


Step 1

1. Shutdown your laptop.

2. Remove the battery.

3. Connect the AC power adapter to your laptop.

4. Power on the laptop

5. Open the Device Manager by typing Devmgmt.msc into Start Menu or from Control Panel.

6. Under the Batteries category, right-click all of the Microsoft ACPI Compliant Control Method Battery listings, and select Uninstall (it’s ok if you only have 1).





7. Shutdown the laptop.

8. Insert the battery.

9. Power on the laptop.

If above suggestions wont resolve the battery charge issue then follow below steps.




Step 2

1. Shutdown the laptop.

2. Remove the battery.

3. Start the laptop with only AC adapter connected to laptop.

4. When you login to Windows OS connect the battery while Windows OS working.





Step 3

Reset the System Management Controller. Use one of these methods to reset the SMC, which controls battery management, battery status light.

1. Shut down the computer and disconnect the power cord.

2. Remove the battery.

3. Press and hold the power button for ten seconds.

4. Reattach the battery and AC power adapter, then start up the laptop.


Hopefully one of the above suggestions will help you resolve the battery not charging problem. If battery still doesn't charge, you may need to replace your battery.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.