Windows 10: kmode_exception_not_handled BSOD with driver verifier files

Hi,I've been encountering the kmode_exception_not_handled BSOD that also points to hidparse.sy. I've followed instructions on other posts to run the driver verifier and have the minidumps file, but I don't know how to read them. Could someone take a look and tell me what drivers I need to fix?Files: https://drive.google.com/file/d/11NXsbfDga9rpnAsWh-pGP0S1xh4YFmmv/view?usp=sharingThanks in advance.

:)

 

Constant BSODs (system_service_exception, kmode_exception_not_handled)

Dealing with near daily BSODs when running intensive software or games. It usually doesn't crash until its under decent load (newer games, rendering, etc.) I have not overclocked my GPU or my CPU. The BSODs I most often get are system_service_exception,
kmode_exception_not_handled, and kernel_security_check_failure.

Another post insisted I ran "Driver verifier." I was able to get the DRIVER_VERIFIED_DETECTED_VIOLATION bsod almost instantly (twice), but neither time did it list the bad driver.

I've provided a link with the downloaded to the dmps, along with msinfo32 and my specs.

ws_4319.zip

 

Driver verifier crashed

I ran into BSOD (specifically KMODE_EXCEPTION_NOT_HANDLED on tcpip.sys) and found this question.

As answer suggests, I followed instruction of this wiki, and driver verifier crashed (DRIVER_VERIFIED_DETECTED_VIOLATION, with no (xxxx.sys)).

As this suggests, I'll upload DMP file and MSinfo output.

dump.zip

It contains two minidump files created within 30 days, and MSinfo output (msinfosave.nfo).

Thanks in advance.

 

Driver verifier not creating dump file

I'm getting frequent BSOD. I started the driver verifier as suggested.

At first, windows stuck at the boot loop, It didn't even show any BSOD. It just kept booting and turning off again and again. It didn't go past motherboard logo.

After some changes in the verifier, It was able to show windows logo but crashed before fully booting to "Driver verifier detected violation"

And it didn't even create any dump file. (All dump file setting are correct one ) As it is known that a driver is causing BSOD. How to know which one?