Windows 10: Laptop not able to log in after factory settings reset.

So I wanted to clean up one of the laptops at home, so I did a factory settings reset. I clicked on save all files and started the reset.During the reset, the computer kept shutting off so I kept opening it and finally, after the reset is over, I tried logging in with the regular account PIN.I entered it and it didn't work. It said I needed to enter the PIN but it was a box designed for passwords when you enter something you have to press enter on password boxes but if you just write the PIN on a pin box you don't have to press enter. The problem is I forgot its password and there was no pas

:)

 

Reset Acer Travelmate to factory settings

Hi all, I have an Acer Travelmate with Win10 (1607), I would like to save Win 10 to a stick, then reset the laptop back to factory settings and then reinstall Win10. There is no program on the laptop that requires saving. Any advice or suggestions, not to technical, would be very much appreciated, thanks Roy

 

Windows 7 Laptop - Cannot reset to factory settings

I have been trying to reset my laptop to sell and followed instructions to reset to factory settings as below

1. Select the category “System and Security” in the control panel.
   
2. In the section “Backup and restore” you can find “Recover system settings on your computer” and then click on “Advanced recovery settings”.
   
3. Then, you need to click on “Return your computer to factory condition
   

I do not have the option Return your computer to factory condition in step 3

Any ideas?

I also have the added challenge that my keyboard does not work as I spilt water on it.

This has taken me hours to try and resolve!!

Any ideas?

Thank you

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".