Windows 10: Laptop occasionally boots to BIOS?

My MSI Thin laptop occasionally boots to the BIOS after start up. It happened today but the last time it happened was months ago but it has occurred since I bought it. Any ideas or could it just be a quirk of the laptop?I have a USB hub plugged in and I note the default BIOS setting is to boot from USB then Windows. Not sure if that could occasionally confused the system?Update: I checked the disk health and that’s 99%. I also just ran a RAM test and after finishing the following occurred: RecoveryYour PC/Device needs to be repairedThe application or operating system couldn't be loaded be

:)

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.

 

Laptop not booting after bios update

Take it apart and try his suggestion is what I would do next. Still what a pain disassemble laptop to fix bios.
RE: Latitude 3330 BIOS update failure
Hi Alex,
sorry about my late. I don't know that you could fix your problem now, but I try help you.
You need remove the Lan card (modular part on motherboard ), because you have a problem with UEFI boot. You can enter in BIOS, if the LAN part is unplugged



RE: Latitude 3330 BIOS update failure







Hy everyone,
I fix this Bios Post error problem.

1. Switch off the computer.
2. Disconnect the AC adapter from the system.
3. Remove the battery from the computer
4. Remote HDD, keyboard, Palmrest
5. Put out the CMOS battery
6. Raise up the LAN/VGA part (2 screws)
7. Take a USB keyboard, connect the AC adapter and press F2
8. If you see the BIOS, almost finished.
9. Put on The CMOS battery, and step in: System configuration / integrated NIC / Turn off "Enable UEFI Network Stack"
10. Turn off and raise down the LAN/VGA part. Test Again. If everything is working you done.

I hope, I could help you
Regards
David

 

bios

Hi all i am new in this forum, i need meanings step by step of each item listed in the bios Phoenix-Award