Windows 10: LAPTOP RESET GOING WRONG HELP

Hello,So I'm currently reseting my laptop and it's been stuck on the "Reset settings to the initial state" 3% screen for 3 Tours. I do realise it can take a long time to reset a computer but this is a bit concerning. Its A Acer laptop. Please help thnx

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

wrong bios programmed on my card what now?

are you kidding? or is this being lost in language barriers?(if so, then id suggest trying google translateon the list above, or reading it several times, im sorry that i cant help with that part) the PCIe slot is what you need, thats where you plug the GPU into. follow the step by step guide, that is your solution. VGA= Video Graphics array, or adapter in this case, AKA GPU, Aka, Video Card.

The 2nd gpu acts as a way to boot into OS since you're not able to do so with the damaged GPU. I don't know what your system specs are but if you have onboard graphics enable them in your bios and then reset your PC or do it after a reset depending on what your motherboard requires that will allow you to boot into your operating system then follow the steps after number three in the list above.( note that if you do not have built-in graphics on your CPU this is where you will use a second GPU )

i hope this helps......Best of luck, i have 35minutes to get dressed, and be on a transport to Kessel.......another day covered in Spice, *Frown (atleast im working in the Refinery *Wink )

 

Need help projecting PC to laptop

That seems a very old version of Connect. What version of Windows are you running on the laptop? Build 17763 suggests it is version 1809. What version are you running on the Desktop?


You could try resetting Connect. Click on Start and type 'connect' then select 'App settings' from the list on the right.