Windows 10: Lenovo P52 BSOD

It seems that windows 11 has some problems with my old Lenovo P52 which is has an 8th gen i7 CPU 6 cores 12 threads with 32GB of RAM installed. Nvidia Quadro P1000 graphics is still supported and I have had to install Windows over and over trying to get the BSOD problem handled.AFAIK all logic on the motherboard is recognized but the finger sensor was set wrong in the UEFI default so changing that to internal allowed me to enroll my finger on the keyboard.Curiously the UEFI also defaults to secure boot disabled so I enabled it so that Windows 11 will boot securely.The P52 had dual M.2 slots

:)

 

Multiple 0x0000009c BSODs on Windows 10 Lenovo Laptop

Symptoms:

• Windows 10 Pro BSODs randomly (after freezing). I have almost 12 identical dumps (attached).
• There seems to be no pattern to it but sometimes it happens when the machine is idle.
• The machine just hangs and then eventually reboots -- most of the time I don't even see a BSOD screen, it just goes from a frozen screen to reboot and the dump is generated.

Steps Taken With No Success:

• Ran full memtest with no issues.
• Clean Windows reinstall.
• Changed from HDD to Crucial SSD.
• Updated BIOS and drivers to what I think are the latest (manufacturer website).

Important System Characteristics:

• Lenovo Z70 laptop with dual Intel 5500 and nVidia GeForce 840M graphics cards
• Virtualization technology is turned on in BIOS in order to run virtual machines
• The BSODs stopped for a good while and then started up again quite frequently lately. I haven't been able to pinpoint any changes in how I use the machine.

Most of the dumps seem to point to intelppm.sys --I'm not sure where to go from here.I have attached the output of the information DM log collector. I have gone through all the files and sanitized them to remove any sensitive personal information (according to me) but that shouldn't affect the integrity of the information.

 

Windows Randomly Suspends While I'm Working

Lenovo P52s (Type 20LB, 20LC) Laptop (ThinkPad)

Thanks for the prompt reply much appreciated

I'll try your suggestions and see how it goes.

 

How to enable touch screen function on Lenovo ideapad 500

Hello,

I suggest you to follow the steps mentioned below to enable touch in Lenovo idea pad. Please perform the steps and check if you can enable your touch screen.

Steps:

• Right click on the Start Menu, locate and click on
  Control Panel.
• Click on View by: Category and change it into
  Large or Small Icons.
• Click on Pen and Touch, once there click on theTouch tab and check the option
  “Use your finger as Input Device”.

For further assistance I suggest you to contact with Lenovo support:

http://support.lenovo.com/us/en/



Hope this information was helpful. Please let us know the status of your issue so that we can assist you further.