Windows 10: libmcl-5.4.0.dll

I have been using slideshow software form some time but now when i try to create an MP4 video i get the following message. "Exception EMon in module libmcl-5.4.0.dll at 000648F3.UNI protocol fault" never had this problem before.

All is well if i create the video in wmv format.

Does any one know what libmcl-5.4.0.dll is ?

:)

 

DLL Missing

The problem is, that the required DLL is not actually even listed there.
There are just dozens of download adware links from the top to the bottom.

 

Bad Image Errors - dll files changing to 0 bytes

Hi
Have an unusual problem (to me anyway)

Last week I got "Bad Image" errors with Adobe Lightroom (the program had worked OK previously). Two .dll files were listed as corrupt and in Explorer both were shown has having 0 bytes size. Re-installation resolved the problem.
Today I have had the same "bad image" error with another program. Techsmith SnagIt. Once again it was .dll files and they show in explorer as 0 bytes. The timestamp on the 0 byte dlls is the time of the error i.e. today (not when the files were installed).

What I've done so far :
Ran McAfee viruscan across all disks - no problems reported.
Ran Malwarebytes - no problems reported

Went to the properties for the disk drive and under "Tools" ran error check - nothing found
The disk is an SSD so I went to Samsung Magician which shows drive condition as good and S.M.A.R.T. shows wear levelling count at Current Value 99. I do not use Rapid Mode.

The problems are happening on a Samsung 850 Evo 500GB

Any suggestions welcome

Dave

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.