Windows 10: Line in port says nothing is plugged in

I am using an aux cord to connect my PlayStation to my PC audio to get everything through the same headset. When i plug the aux cord in however, the line in port says there is nothing plugged in. I had this previously working with a Nintendo Switch but now it doesn't seem to be working. I've already uninstalled and reinstalled the drivers for it and that didn't work. Any ideas?

:)

 

Rear audio ports always show as “Not plugged in”


I've been having this issue with Windows for about a week now which NONE of the back panel/front panel connectors (speakers, microphone) are being recognized by Realtek audio manager. The only audio input/outputs that are showing are the optical.
Troubling shooting steps I've tried (none worked):

• COMPLETELY uninstall all Realtek drivers/reinstall
  
• Tried using windows drivers
  
• Reinstall Windows 10
  
• Upgraded chipset driver
  
• sfc /scannow

I called EVGA and asked for RMA but then I booted into a Ubuntu OS and all the ports work FINE. It must be a problem with windows 10.
Can you think of any other troubling shooting step I can try to fix this annoying issue? Thanks!
Screenshot of playback devices:



Screenshot of Realtek HD Audio Manager:



After looking in Device Manager under Audio inputs and outputs, I don't see any speaker/microphone listings, only the optical crap:

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

How do I get Win.10 to recognize a USB plug-in?

I will try to go step by step. I download ver. 4.5 9.
1. Setup has finished copying files to computer.
2.Plug Spyder in before launching Spyder4 Elite. I plug in Spyder
3. click next
4. I launch Spy.4 Elite. It says please select your sensor from following dialog. (Nothing in dialog to select)
5. A window comes up that says no sensor detected, and below is Spyder4 ccp 156 131331(0x20103). I looked at there site and it had an error Ref.#1564807421 Error code 131331error message no sensor detected.