Windows 10: Location setting?

How do I reset the computer location in Windows 10

:)

 

Location setting

Hi,



This issue could occur due to incorrect location settings or it would depend on your IP address. We suggest you to check the location settings of your PC, and check if it helps. Here are the steps:

• Click the Start button, and select Settings.
• Go to Privacy, and choose Location.
• Make sure that the Location service is On.

If issue persists, then it has something to do with your IP address. It’s because the location detected depends on the location set on your IP address.



Let us know how it goes.

 

Unable to turn on the Location from the Location Settings.

Hi Rafiul,

It is possible that the
GPS chipset
is not working properly causing your location settings to be
disabled or cannot be turned on. Kindly run the
Hardware and Device Troubleshooter
and check if there's any changes. To run the
troubleshooter, follow these steps:

• 
  On the search bar, type
  Troubleshooting
  and hit
  Enter.
  
• 
  Choose
  Hardware and Sound.
  
• 
  Click on the
  Hardware and Devices
  to run the
  Troubleshooter.
  

If the issue
persists, we suggest that you contact your
computer/laptop's manufacturer
for further assistance.

Update us on how it goes.

Regards.

 

Location service is greyed out

Hi Shahriar,

Thank you for responding.

Sorry for the inconvenience caused for you, I suggest you to try the below troubleshooting steps and check If it helps.

Step 1: Steps to turn on the Location settings.

• Login as an administrator.
• Press Windows key, type Location settings and select
  Change location settings.
• Check whether Location for this device is On by clicking on
  Change.
• Also turn on Location as well.

Step 2: And as you are unable to set the service Geolocation service to automatic, I suggest you to run SFC scan and check.

System File Checker is a utility in Windows that allows users to scan for corruptions in Windows system files and restore corrupted files.

Follow the below steps:

• 
  Right click on the Start button, click on
  Command Prompt (Admin).
  
• 
  Type “sfc /scannow” without the quotes and hit
  Enter.
  
• 
  After the scan, restart the computer and check for the issue.
  

Try to set the service to automatic by following the steps provided in the above post by Praveen Venugopal.

Hope it helps. Kindly update the status of the issue, we will be happy to help you.