Windows 10: Login after factory settings

Hi, I tried to factory reset my computer, but after the "loading screen" it take me back to my profile, into which after I enter the password "You device is offline..." before that it told me that the microsoft account cannot be accesed or something like that. I tried to click power button then shift click restart and do factory reset from there but it does it again :

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Can't login to new computer w/Windows 10

Hi,

Thank you for your reply.

• 
  Are you able to login to Microsoft Account on Web?
  
• 
  Have you installed any language pack?
  

I suggest you to follow the steps below and check if it helps.

Step 1: I suggest you to select the appropriate language in login screen at the bottom right corner and check if it helps.

Steps 2: Use On-screen keyboard in the login screen to login and check if it helps.

Hope this helps. If the issue remains unresolved, please get back to us and we would be happy to help.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.