Windows 10: LOOP after Reset [Blue Screen, “Why did my PC restart?”]

Hi everyone,I’ve searched all day for a solution to this problem and finally I thought , “Hey maybe I should just post it on the Microsoft Help Forums!” Haha. So here I am. So, my PC was running into some smaller problems, so I decided to do Restart, deleting files, reinstalling Windows 10. I’ve done this a million&nbs

:)

 

Blue Screen loop after resetting PC.

After having some issues beforehand, I decided to reset my PC to start off on a clean slate, but immediately after, my computer began to go under a boot loop, and constantly hits a blue screen that says:

"Stop Code: 0xc000021a"

I'm not even able to access the login screen. Repeatedly pressing F8 or F12 doesn't bring up any menus and I can't find my Windows 10 disk that I installed the OS with. Any help and suggestions would be appreciated.

 

Windows 10 crashed and now stuck in restart loop with a blue screen


Hey guys, I am hoping you can help me. Last night I was watching a dvd on my desktop when all of a sudden a blue screen came up with a frowning face and said that "Your computer ran into a problem and needs to restart, its collecting info and will restart." It happened quickly so I didn't see what the error was but now my PC is stuck in a loop where it restarts and loads into an empty blue screen. It stays on that blue screen for a minute or so and then restarts again. I tried going into my BIOS or starting in safe mode but my PC won't go into them. Can I fix this?

 

Blue screen and stop code

Hi
Jeferis,

There are a lot of factors for this matter to occur. To isolate the issue, we have some questions for you:

• 
  What activity have you done to
  trigger the NTFS and FAT FILE SYS loop?
  
• 
  were there any error messages?
  
• 
  What troubleshooting steps have you done so far?
  

It is possible that the
Boot
Sequence were corrupted by the previous activity which
triggered the Blue Screen Error and the loop. We recommend that you perform these
suggested troubleshooting
and see if there are any changes:

Startup Repair.


To access the
Startup Repair Screen, turn off the
PC 3-4 times(force shutdown),
while on the Blue screen Error. This will route you to the
Startup repair screen:

Advanced Boot Options > click Troubleshoot > Advanced options > Command Prompt

and run the following command:

Run SFC Scan:  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Boot Record:

This will fix the corruptions on
boot records or boot
sequence. To run this command, follow these steps:

• 
  Run
  Command Prompt as Administrator.
  
• 
  Type the following command:  
  
  • 
    Bootrec /fixMBR  
    
  • 
    Bootrec /fixBoot
    
  • 
    Bootrec /rebuildBCD
    

Update us on how it goes.

Regards.