Windows 10: low audio after formatting

hello I went from windows 8.1 to windows 7 so far so normal but when I went to see a video with the generic driver "High Definition Audio Device" and then I noticed that the sound was low was **** look at the mixer volume was all at maximum then I was a little research and installed my audio driver that alias and VIA HD The volume is still low and even so I tried everything I went to improvements and enabled equalization but nothing changes I tried to download a program to increase the sound up to 500% but the volume is still the same and also uninstall the original driver and then install a

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Low Level Format Question

Low level format is basically setting all and any bit of information on the plates to 0. There should not be problems with IDE drives, but I've never try it on one so I can't be sure. Most of the manufacturers provide some software witch you can use to low level format their HDDs and will have a list of supported drives. I think that running low level format for 2-3 times will be more than sufficient.

 

Can not record audio.

Hi,

We suggest that you run troubleshooting for Audio Recording by following these steps:

• Type troubleshooting on the search box.
• Click View all.
• Select Recording Audio.
• Follow the steps to troubleshoot Recording Audio.

Let us know if you need further help.