Windows 10: Macrium Problem??

I have noticed this happening when I select "Create an image of the partition(s) required to backup and restore Windows." I have 4 partitions all are checked by default but when I choose "Create an image...." only some of the partitions were being checked and imaged? i.e. Patition 1 and 3 were not (auto)checked nor was an image made for them*Eek Happened to me last week when only one was not checked, seems inconsistent?? Never had to recheck the selection before.

:)

 

Restoring Windows 10 Image using Macrium Reflect


In addition to the above. Here's my suggestion in step by step.
I assume you have Macrium Installed in your current HD and already made a backup copy.

• Connect your new HD via USB port and boot up.
• Run Macrium, click on Restore tab then select the Backup Image that you made to restore
• click on "select a different target disk" then select your new HD as destination
  
  
  
• Proceed to restore then Shutdown and disconnect the old HD and replace with the new HD
• Boot up with your new HD.

 

Windows 10 1709 System Restore problems...


That seems to be an attempt at Option 2 in the tutorial, which requires you to
a. Boot to a command prompt (Did you?)
b. You then seem to be mixing steps 3,4 and 5, thus your command is incorrect.

I suggest Option 1 is easier.

If you still have problems, please repost listing each specific step and saying which option from the tutorial you are using. Thanks.

 

System Image Problem


I'm getting a head start in case you get on early.

Can you post camera pics to your thread from your phone?

There will be steps later that require attention to detail and I'd feel better if I could see what's on your screen. I had to try the steps more than once when I tested the process and I'd like to avoid that on your machine.

Here's what I'd like to do for the Macrium Rescue steps later on in the process
I'll post the the step, you'll post an picture of the Macrium screen,
I'll echo same screen back if I see something that needs changing or I'll just say Go Ahead

When I confirm that the Macrium screen, you'll make any changes I've highlighted and THEN execute the step

Here's where you begin today's session, we'll get as far as we get and then pick up when you get back home.

Step 1: Safeguard the System Image by moving it to a new folder

• Connect the Seagate exp drive
  
  
• File Explorer: Navigate to the Seagate drive
  
  
• Create a new Folder named 1_sysImage
  
  
• Move WindowsImageBackup to 1_sysImage

Step 2: List the VHDs in the System Image

• File Explorer: Navigate to 1_sysImage\WindowsImageBackup\machineName\Backup date-time
  
  
• Press the Type column to sort by Type
  
  
• Post a screen shot