Windows 10: Mapped network drive is too slow - ANF Network share.

We have an archive folder in a network share which is mapped to our sap system consisting of files close to 900000 and the response time of the network drive is too slow while accessing the particular folder. it takes more than 30mins to load.Could you please suggest what actions could be taken to improve the performance apart from deleting files from the folder?Is creating subdirectories and distributing files among them will help.?Thank you,Manjuprasad

:)

 

cannot open files on network shared drive

I have used a small handful of applications that just won't open a \\host\share\file.ext

Annoying, but there may be a workaround, try mapping the share to a drive letter:

In Explorer, Tools > Map network drive...





Then choose an unused drive letter, and the shared folder.





This will work for most programs as it'll see K:\kitchen.kit

 

Trouble Mapping Network Drive

I have a WD NAS drive connected to my router and have mapped it on three of my computers. I just setup another laptop with Windows 10 and have updated it to 1809 and when I tired Mapping a network drive nothing is displayed in the browse window except the
computer I am currently using. The drive is shown under network locations in File Explorer but not when you select map network drive and browse. I right clicked on the drive and selected properties and noted the IP address and went back into Map network drive
but instead of selecting browse I entered the IP address but it still does not map the drive. The strange part is if I go to any of the computers that already has the network drive mapped and select Map network drive and select browse none of those computers
show the drive either but you can select the mapped drive in the drive list in file explorer and it works just fine.

I have read several articles both here and elsewhere and tried the suggestions but nothing works. Network discovery is turned on as is file sharing and also checked if all three boxes under SMB file sharing support in Windows features were also checked and
they are. I have mapped several computers to several different drives over the years and anytime the drive was not listed it was always easy to go into Network Sharing Centre and find the problem but everything seems to be as it should so would appreciate
if someone can suggest something I may have overlooked.

Thank you

 

Help needed with simple wired network

Step one- Connect all PC's to router, and then the router to the modem. PC's go to router by the ports labeled "1-4" on the back of the router. WAN port goes to router. Power up all network equipment, and then systems.
Step two- Power on the computer connected to port one. Go into router settings at 192.168.0.1 and configure internet, dyndns, firewall, etc.
Step three- Go to "network set up wizard" in windows. (Network places- network set up wizard). The rest is self explanatory.
Step four- right click on each drive and printer you want to share, and then configure sharing preferences. Should be easy enough.
Step five- right click my computer, and the select "map network drive". Using the network address for each piece of hardware you shared, assign network drive letters.

Congratulations, you have a fully operational network. Happy Gaming! *Toast :toast: