Windows 10: Maximum charge level

I limited my laptop charging level to 80% on windows 10, since updating to windows 11 I am unable to change this setting. How can I change my maximum charge level back to 100%?

:)

 

My Computer is Plugged in but not Charging

My laptop computer is plugged in but not charging. The power supply will maintain the charge level (%), but not add to it. Removing and reinserting the battery allows the power supply to add to the % charge to 100%.

Steps performed:

• Turning the computer off and restarting it returns the computer to the Plugged in, Not Charging state.
  
• Removing the battery again allows one complete charge, after which the laptop would no longer charge again.
  
• I have used more than one power supply with the same condition.
  

To resolve the issue, I remove the battery, obtain a complete charge, and maintain this charge by always keeping the power supply plugged in.

What is the root of the problem?

 

Battery Won't Charge Fully

Make sure to install all Windows important updates.

Install latest versions of your laptop device drivers you can download the latest device drivers from the device manufacturer or from your laptop manufacturer website.


Step 1

1. Shutdown your laptop.

2. Remove the battery.

3. Connect the AC power adapter to your laptop.

4. Power on the laptop

5. Open the Device Manager by typing Devmgmt.msc into Start Menu or from Control Panel.

6. Under the Batteries category, right-click all of the Microsoft ACPI Compliant Control Method Battery listings, and select Uninstall (it’s ok if you only have 1).





7. Shutdown the laptop.

8. Insert the battery.

9. Power on the laptop.

If above suggestions wont resolve the battery charge issue then follow below steps.




Step 2

1. Shutdown the laptop.

2. Remove the battery.

3. Start the laptop with only AC adapter connected to laptop.

4. When you login to Windows OS connect the battery while Windows OS working.





Step 3

Reset the System Management Controller. Use one of these methods to reset the SMC, which controls battery management, battery status light.

1. Shut down the computer and disconnect the power cord.

2. Remove the battery.

3. Press and hold the power button for ten seconds.

4. Reattach the battery and AC power adapter, then start up the laptop.


Hopefully one of the above suggestions will help you resolve the battery not charging problem. If battery still doesn't charge, you may need to replace your battery.

 

Acer battery won't charge

What if the battery unremoveable? Should I disassemble and remove it? also there is a switch underneath the case and around the RAM slot that prevent the laptop to turn on when the case is open and without the charger. Is that the same as removing the battery? although when turned on with charger, the laptop still see the battery. Thanks

- - - Updated - - -

I took the report, the design capacity was 41.440 mWh but full charge capacity is now 25.752 mWh. Is it that bad? Before this happened I believe HWMonitor also show the same number with 38% Wear Level.
Here's the report file