Windows 10: MediaCreationTool1809 flash drive option?

Hi, MediaCreationTool1809 does allow me to choose install on a flash drive (for another PC choice) but when I select "next" it goes to work only to say that I have not enough space on C: drive, no option to select which flash drive or ISO location. In fact I do not have enough space on C: why should I ?

:)

 

clean possibly infected flash drives and CD-RWs

Your steps in post #1 should work for 99% of viruses that may be on a usb flash drive. However, there are a very few viruses that can infect the MBR of a drive. I would use Diskpart from a command prompt (Admin) to clean them. In the command prompt type DISKPART then, at the Diskpart prompt use the commands:

LIST DISKnote the disk number of the usb and use it in place of # in the command:SELECT DISK #
CLEAN
CREATE PARTITION PRIMARY

After this you will have cleaned the partition table from the usb and created a partition using the whole of the the available space. You can then format this partition in File Explorer.


For a CD-RW, if you right-click on it in File Explorer there is an Erase option.

 

CD to flash drive

Hi Pam,

There are several ways to copy your pictures from the CD to the Flash drive. One of which is by using the shortcut keys to copy and paste it.

We suggest following the steps below:

• Insert the CD and flash drive to your PC.
  
• Use Cortana and type File Explorer then click it.
• Choose This PC.
• Open the CD drive.
• If all the pictures are in a specific folder, press Ctrl + A
  on your keyboard to automatically choose all the pictures then, press Ctrl + C to copy it.
• Afterwards, Open the Flash drive, choose the location where you want to copy the pictures then press
  Ctrl + V to paste it.

Let us know if you need anything else.

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!