Windows 10: Memory Integrity & Kernel-mode Hardware-enforced Stack Protection OFF After Restart

I realised that my Windows Security icon on the bottom right of my toolbar had a little yellow caution symbol on it so I clicked to check it out and I saw that the Memory Integrity & Kernel-mode Hardware-enforced Stack Protection buttons were off. I turned them on and then restarted my laptop, however I checked and they were still OFF.I have tried some proposed solutions like using PowerShell and CMD and also repairing the Windows security application however none of these have worked. I also got the blue screen error that reads Stop Code: SYSTEM_THREAD_EXCEPTION_NOT_HANDLED.Could someone

:)

 

memory integrity and kernel-mode hardware-enforced stack protection getting off automatically after restart

So I installed Valorant and there was a file named "vgk.sys" in Riot Vanguard which was showing incompatible and caused memory integrity and kernel-mode hardware-enforced stack protection off. To enable those, I uninstalled Valorant and turned those two on. It asked to restart my pc to enable these two options. But during restart it is showing an error message "Your pc ran into a problem and it needs to restart". It restarts on its own but after the restart, the memory integrity and kernel-mode hardware-enforced stack protection gets turned off automatically.

I did sfc /scannow but it did not find any integrity violations.

How to enable those two now?

 

memory integrity and kernel-mode hardware-enforced stack protection getting off automatically after restart

Unfortunately, the issue stays.

After turning on these and restarting, the "your pc ran into a problem" still happens and these two are still getting off automatically after the restart. The main problem is with kernel-mode hardware-enforced stack protection. If I turn on memory integrity only and restart, it works fine. But when I turn on kernel-mode hardware-enforced stack protection, both of them turn off automatically after the restart.

I doubt whether the PowerShell command worked or not since it did not send any reply or confirmation message.

 

Cannot enable Kernel-Mode Hardware-enforced Stack Protection

I had the same issue. I just disabled Memory Integrity and rebooted after this the managed by administrator thing disappeared. But now I realised I can`t turn off Memory Integrity complitely. After rebooting it stays on and although the toggle switch for the Kernel-Mode Hardware-enforced Stack Protection is working now it still stays off after PC restart.