Windows 10: Memtest86+ passes. WIndows 10 has errors and BSODs.

My memory: Corsair Vengeance LPX 32GB 4x8GB CMK32GX4M4E4133C19.

I run @ 4000Mhz. 17-17-17-38-2CR. Memtest86+ can run for 24 hours with no errors. Windows 10 Pro also doesn't have any issues running my memory with this speed and timings.

When I run Memtest86+ at 4100 and 4133 with relaxed timings I can also run 24 hours with no errors. However, when I am in Windows 10 Pro I get errors and BSODs that are without a doubt related to my memory speed and/or timings. A good indicator that Windows 10 doesn't like my memory settings is when I run a verify on disk images I have taken. The MD5 hash isn't the same which results in my inability to restore the disk image as it fails in the disk imaging PE environment..

Obviously Memtest86+ is not the definitive test for memory as one might expect. What is it about running the same memory timings and speed in Windows 10 that are causing memory failures while Memtest86+ passes all tests?

BTW.. The only change in my UEFI is memory speed and timings.

:)

 

BSOD - Registry Error

Your BSOD code is 0X000000051

Here's the Google search I did for it: https://www.google.com/search?q=0x0...j5.399j0j7&sourceid=chrome&es_sm=122&ie=UTF-8

There is a hotfix available that might help, https://support.microsoft.com/en-us/kb/810558

This thread makes a few good suggestions too: http://www.sevenforums.com/bsod-hel...dows-7-pro-sp1-registry-error-0x00000051.html

+1 to listing your full system specs, OS version, etc. I did only look at your BSOD log file.

Run a Diskchk /R (I know you already ran one, so you can skip this)

Run SFC /SCANNOW

Report back.

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

Memtest86+ reports 0 errors after 8 passes


I am currently running Memtest86+ 5.01, as suggested, and I am a bit concerned that there is a line that says:
Cores: 1 Active: 1 / 1 total (Run: All)

I in fact have 4 cores, and the top line on the screen identifies it correctly as an Intel Core i7-4770k

It is still running as it has completed only 1 pass so far.

Screenshot:
Attachment 36290