Windows 10: Mic output reset after each new call

Hello there !

I'm facing this problem for a lots of time now and I still didn't get a proper way to definitly fix this

After each new call discord or anything else i need to change my db level, even if it was 20, if i put it to 10 and go back 20, it will work correctly...

If someone have a good solution for this I'm open, I already tried a lots of thing

I'm on Win10 and all drivers are up to date

Thanks in advance !

:)

 

USB Mic Problems.

The next step is what I suggested originally. Try it in a friend's PC or take it to Best Buy and ask them to try it one of their PC's. Have to confirm the mic is working OK.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Mic/Headphone ports not working correctly - Acer Aspire 7745

The speakers are 'plugged in' already as it is a laptop. With no external mic, headphones or external speakers plugged in, the Sound Control Panel lists three things under 'Playback' - HDMI, 'Speakers' and 'Realtek Digital Output' - the Speakers under 'Playback' is set as the default.

Under 'Recording' with no external mic plugged in these are listed - 'Microphone', 'Line In' and 'Stereo Mix' (Disabled) - the microphone (in this case, the internal one) is set to 'Default' under 'Recording' as well.

I don't have my headset here to test an external mic right now, but with normal external headphones plugged in, there is no change to the Sound Control Panel under 'Playback' - the same three listings (HDMI, 'Speakers' and 'Realtek Digital Output') with 'Speakers' set as the Default. If I make a noise, say, play a video, I can see the sound meters move to the sound, but no sound comes out of the headphones.