Windows 10: Micro doesn´t work anymore after Windows 1909 update

Hello, thanks for reading this since that mean you are going to help me... Firstly, with microphone doesn´t work i mean it doesn´t get input sounds despite the fact it gets detected and apps are using itIt is shown by this new update in lower right corner.

It is not micro problem since I tested it 5 minutes ago on phone and Works fine.

This headset uses its own driversPlantronics Blackwire 5220 Series and I already tried reinstall drivers. Sadly micro still doesn´t work.

Output device Works well, so after try everything I could try to fix itCheck micro settings, micro volumen...., I came up with two possible problems:


Windows configuration is glitched with the new update and micro volumen is in zero or it is muted somehow although it says 100 and it says it isnt mutedMy headset has his own "Mute button", it is obviously syncronized with f4... or, maybe it could be that new driver called NVIDIA Virtual Audio DeviceWave ExtensibleWDM could make this issue? I dont remeber have seen it before the Windows update, and in the log it says ROOT\UNNAMED_DEVICE\0000 requires of instalation; Controllers setting finished installation of … state: 0x0 the day I updated Windows.


Hope you help me with this Windows Software issue as soon as possible.

PostScript: I checked integrated micro of my laptop and WorksBut with horrible sound comparing it with the sound I have had with Plantronics headset and I need to talk with high quality for my meetings.

:)

 

Scanner doesn´t work anymore after last Windows 10 update

As many people on the internet already are discussing, their scanner doesn´t work anymore after the last Windows update. But there seem to be no solution.

My Scanner starts making noises, as usual, and then i get error messages: "Communication with the scanner is not possible"
or this




Is there a workaround for that?

 

Scanner doesn´t work anymore after last Windows 10 update

I dunno.

Re-install the TWAIN drivers? (They are not included in Windows.)

You might get a better answer if you gave the make and model of the scanner.

 

Windows doesn`t start. Authomatic repair doesn`t work.

Thanks again!!

I`m sorry I had not noticed that the text on the picture was in spanish. It says that windows has replaced some damaged clusters in "name" file and "directory". Then, at the end "an unspecified error occurred (75736e6a726e6c2e 4f6)".

I`ll do it and I`ll be updating this thread when I have the report.

- - - Updated - - -

I ran SeaTools. These are the results:




Does it mean my HDD is useless?