Windows 10: Microsoft RRAS as an entry point to the corporate network

We have the following infrastructure.There are two networks. One 172.31.0.1/16 with gateway 172.31.0.1 and another network 100.80.0./24 with gateway 100.80.0.126Our server with the role of RRAS which has ip 100.80.0.100I raised a role with ip range 172.28.0.0/24I ping the gateway of the internal network 172.28.0.2 and the ip of the network card is 100.80.0.100But I can't access any of the hostsI tried to make a static route to the network 100.80.0.0 through 100.80.0.100, but unfortunately it did not help.Does this product actually work in this mode? Or am I just wasting my time.Our goal is to

:)

 

SoundA.exe - Entry Point Not Found

Every time when i boot up my
computer I receive the following error message: SoundA.exe - Entry
Point Not Found The entry point of the clCreateCommandQueueWithProperties procedure could not be located in the dynamic link library C: \ User \ ahmed \ AppData \ Roamin \ Microsoft \ SoundMixer \ Artic \ SoundA.exe.

Please urgently suggest solution for this error it's very irritating.

Move from: [Windows / Windows 10 / Windows settings]

 

"Microsoft Corporation" is missing as Manufacturer in Device Manager

As the title suggest the manufacturer section when adding a legacy hardware is missing the "Microsoft Corporation" but "Microsoft" is still there listed.

I'm trying to install RNDIS Network driver for my Raspberry Pi Zero W, but it looks like I can't ssh through using USB. Sadly I also don't have any monitor to use so I'm trying to install it headless.

Edit: I forgot to mention I have installed Windows 10 Enterprise Edition v1709

 

Can't get rid of a network entry in W10 navigation panel

Hi Dee,

If you wish to remove/delete a network entry on Windows 10 navigation pane, we suggest that you follow the steps below:

• Open a command prompt.
• In the command prompt, type-in the command below and press Enter.
  
  NOTE: Substitute Z: in the command below with the actual drive letter of the mapped network drive that you want to remove from your computer window.
  
  net use Z: /delete
  
  
• When you're done, close the command prompt. The mapped network drive should now be removed from your Computer window.

We would appreciate it if you could get back to us and provide us your feedback.