Windows 10: Moniter power up but fails to show anything.

Windows 10 version 1909.

I just installed a new to me graphics card in my wifes desktop but the moniter shows a blue screen, a message saying HDMI no signal and then goes black. I changed the cable back to the on board graphics but it does the same thing. Everything was OK before I made he card change. Suggestions please, the wife is NOT happy with me at the moment.

:)

 

Moniter power up but fails to show anything.

Windows 10 version 1909.

I just installed a new to me graphics card in my wifes desktop but the moniter shows a blue screen, a message saying HDMI no signal and then goes black. I changed the cable back to the on board graphics but it does the same thing. Everything was OK before I made he card change. Suggestions please, the wife is NOT happy with me at the moment.

 

Toshiba PC Health Moniter

So, i just recently got toshiba PC health moniter, and it wont launch. Any suggestions?

 

moniter going sleep cant get it to stop during webcams

Hi Rikard,

Thank you for posting in Microsoft Community, we appreciate your interest in Windows 10.

I understand the inconvenience you are facing with accessing the computer as the monitor goes to sleep while streaming the videos.

Do let us know the following to assist you better with this issue:

• 
  Is this issue persists only when streaming the videos?
  
• 
  From where are you trying to stream the videos?
  
• 
  Have you made any changes to the operating system prior to this issue?
  

I suggest you to try few of the below troubleshooting steps and check if it helps.

Method 1: I suggest you to run power troubleshooter and check if it helps. Please follow these steps:

• 
  Type troubleshooting in the search box on taskbar and click on it in results.
  
• 
  Click View all and then click
  Power.
  
• 
  Click Next and follow on-screen instructions.
  

If the issue persists,

Method 2: I suggest you to restore the power plans to default
and check if it helps.

Steps:

• Right-click on Start button
  and click on Command Prompt (Admin).
• In the command prompt, type powercfg –restoredefaultschemes
  and hit Enter.
• Exit command prompt.

Note: This would reset the power plan settings to default. Any customized power plans are would be removed.

Hope it helps. Kindly get back to us with an updated status of this issue and required information for further assistance.