Windows 10: Monitor doesn't receive any signal and it seems to be a windows issue

my pc turns on normally with display but then 3 seconds into the login screen the display black screens and says "no signal detected". my peripherals which are plugged into my monitor still work. and my second monitor does still work so i can still do stuff on windows on that monitor.cable should be connected firmly, tried restarting the pc alot of times, removed and updated drivers and tried restarting windows explorer.and i believe that it has got something to do with windows, because bios does work as normal without any issues.this happened all of a sudden when trying to turn my pc on after

:)

 

Windows doesn`t start. Authomatic repair doesn`t work.

Thanks again!!

I`m sorry I had not noticed that the text on the picture was in spanish. It says that windows has replaced some damaged clusters in "name" file and "directory". Then, at the end "an unspecified error occurred (75736e6a726e6c2e 4f6)".

I`ll do it and I`ll be updating this thread when I have the report.

- - - Updated - - -

I ran SeaTools. These are the results:




Does it mean my HDD is useless?

 

Gainward 4850 dvi to dvi "no signal" issue

recently i bought viewsonic vp2365wb and since then can`t get it to work thru dvi conection.
I tried with several dvi cables, still doesn`t work. it just says no signal and the display immediately goes to standby (no picture at all, nor boot, BIOS or windows). through vga it works but limited. after installing several drivers (display and graphic cards) it still doesn`t show the proper resolution and/or refresh rates, which is a first for me, to have a display that doesnt work properly over VGA by it's native resolution.. reinstalling drivers doesn`t work.


any suggestions??

my specs:
Windows 7 32
asus p5ql pro
intel quad q6600
gainward radeon 4850

 

HDMI no signal only during Boot

Hey Guys,

I've just built myself a new computer, all working well, however on boot my HDMI monitor receives no signal until Windows has fully loaded. It would receive signal to see the Bios screen pop up then go blank with no signal and then about 5 seconds later will receive signal and display the desktop.

I've now added a second monitor connected via DVI, even though this is not set as my primary monitor the bios screen displays on it and I can see the entire boot process through this monitor, it will then load to desktop of which a split second later my primary HDMI monitor will then receive signal and start to display.

It's not a massive issue but it's quite annoying, any suggestions?

I'm using a GTX 970 and Windows 8.1 Pro 64-bit.

Cheers,