Windows 10: Monitor turning off when resetting PC

I was given a gaming PC. The person who I bought it off of did not factory reset the PC when he sold it. I go to reset the PC but my moniter turns off and it disrupts the resetting process, what do I do?

:)

 

Pc turns on, but will not display anything

So as the title says my pc will now turn on, but it will not display anything on the monitors. i have tried one and both monitors.

list of what i have tried

putting my video card into my dads computer.
resetting cmos by taking bat out for 10-15min


thats all i have tried but it worked before i had turned it off from it being plugged into my tv.

I don't know what to do again, Arg i am starting to hate pc's i want a mac so bad now.......

thanks for the help in advance.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??