Windows 10: motherboard has a while light next to the bios reset, and my entire pc stutters/freezes...

this has been going on for a while now, i tried updating my drivers but havent seen a difference.

:)

 

GPU-Z 0.7.8 / 0.7.9 / 0.8.0 Bios reading not possible GTX670-solved with gpu-z 0.8.1

@Maban - does GPU-Z fail the same way for you the way it does for me? I.e. total system freeze/lockup, requiring a hard reset?

@W1zzard - I will try the suggested steps later today, as I am not near that PC at the moment.

 

stuttering after factory reset of PC

Hello,

My PC is having a stuttering issue after factory resetting my PC and games are now impossible to play without extreme stuttering. I only experience mild but manageable stuttering otherwise. My task manager does not indicate that anything is being overloaded when this is happening.

I have made sure to install all of the updated drivers, made sure my BIOS is updated, have tried things like the system file checker and the DDU.

I have a Z97-GD65 GAMING motherboard, MSI geforce gtx 970 graphics card and i5 4690k processor.

Only thing I changed from before I factory reset was booting my PC in UEFI mode instead of legacy mode which I dont see how this could be the issue.

Thank you for any help

 

Resetting Bios Password

I am doing some spring cleaning, getting rid of old desktops, laptops, and routers. Regarding the computers, I am wanting to wipe the hard drives with Darik's Boot and Nuke software. When I booted up one old Dell desktop from 2001, I learned that it requires a BIOS password. Why I ever put one on is beyond me. Unfortunately, I have forgotten the password. The rest of this message will be about wanting to know if my understanding for resetting the BIOS password is correct.

Technically, this thread/message isn't about Windows 10 specifically. But it does relate to hardware, and I am hoping that it would apply to a significant number of computers, so I hope this message is okay.

I called Dell, and the technician said that I needed to reset the jumper on motherboard to reset the BIOS password. After opening the case on my old Dell computer and hunting on the internet, this is the what I think I have learned. I will present photograph of a portion of the motherboard.





I have put a red rectangular box around what I think is the jumper for the BIOS. I note that "PASS" is written on the motherboard beside those three pins.

I believe these are steps I need to follow. Please correct me if I am wrong.

1. Turn off and unplug the computer. (It has been off and unplugged for about ten plus years. I just plugged it in today. I am not sure if this information is relevant. Perhaps it helps with regard to the motherboard's battery.)
2. Open the case and locate those "PASS" pins again.
3. Switch the jumper from the current two pins to include the third pin and middle pin. Leave it there for 5 seconds or more. In other words, move the jumper over one pin for a few seconds.
4. Reset the jumper back to its original position with the original pins.
5. Plug in the computer, and attempt to boot it up.
6. Assuming it boots up, open CD tray and put in Darik's Boot and Nuke software and follow the steps.

Is there any information that I am missing? Do I have the correct location for the jumper? Are my steps correct?

Thank you for your help.