Windows 10: mouse cursor speed reset to 10 after each update

For reasons that I can't understand, my mouse cursor speed has to be set higher than 10. 16 to 18 seems about right. But every time I get a Windows 10 update, the cursor speed is set back to the default 10. So, I have to go into Settings and increase the cursor speed again. Is there anything I can do to preserve the cursor speed across Windows updates?

:)

 

Click and drag keeps speeding up on touchpad

Hi,

Do you face this issue while moving the mouse cursor normally on the desktop screen?

If yes, I suggest you to follow the below steps in order to slow down the mouse cursor speed.

• Go to control panel.
• Click on mouse.
• under pointers options tab adjust the pointer speed, click
  apply and ok

let us know the status of the issue to assist you further.

Thank you.

 

Mouse Cursor and pad cursor - Acer Aspire Lap Top.

Hi Tess,

Based on the description that you mentioned, you're having challenges controlling the mouse cursor. It looks like we will need more information about your concern in order to give the most appropriate advice. As such, please answer the following questions:

• Did make any changes to your computer prior to this issue (e.g. updating Windows operating system, hardware changes, etc.)?
• Can you please tell us more description of the behavior of the mouse cursor?
• What troubleshooting steps have you tried so far?

In the meantime, we suggest that you refer to the link below for helpful tips and steps on how you can resolve this issue:

Mouse, touchpad, and keyboard problems in Windows

We also suggest that you update the drivers in
Windows 10 as this process will apply new features and fixes that are essential to your hardware drivers.

We're looking forward to your response.

 

No mouse cursor

Hi,

It is possible that the system did not recognize the mouse of your computer after it booted up. This can be the reason why you do not see the mouse cursor. Kindly perform a power cycle to refresh the power of the computer. To do this, follow these steps:

• Shutdown the computer.
• After shutting it down, remove the battery (if you're using a laptop) and disconnect the computer from the charger.
  
• Wait for 1 minute.
• After 1 minute, attach the battery and turn on the computer.
• Check if you will see the mouse cursor.

Let us know how it goes.