Windows 10: Mouse Cursor Speed Reset Upon Reboot

Every time I reboot, my Mouse Cursor Speed is reset and I must go into the Accessibility Setting to change it back to a usable speed. This began happening within the last two weeks. How can I permanently set the speed to prevent this? I have a RedThunder M10 Wired Optical Gaming Mouse that has no third-party software controlling it, there are only Windows settings. Windows Version 22H2 OS Build 22621.2134.

:)

 

Mouse cursor speed suddenly reduced

This is getting annoying. Even after the steps mentioned above, the cursor speed got super-slow. (To get across the screen was taking 7 to 9 movements of the full width of the mouse pad.) But it returned to normal in some apps, then got slow again when I left those apps. I tried replacing the batteries -- no difference. Then I looked at the mouse cursor speed, which I had left set to 16, and found that Windows (or some virus) had been reduced it to 8. I increased it to 20. Back to normal cursor speed. I left the computer for a couple of hours, and returned to find that the cursor speed was now super-fast. Much too fast. I set the cursor speed back to 12, and now it seems normal again.

Help!!

 

Mouse cursor displayed without offset

When the mouse cursor changes to one that should be displayed with an offset (e.g., the hand cursor should be displayed slightly to the left so that the tip of the finger matches the mouse position) it is not and instead is drawn with the same position as the default pointer.

This is not specific to any program. Hovering a link the web browser shows the hand cursor to the right of where it should be. The cross-hair pointer in paint is down and to the right of where it should be. The I-beam cursor for text selection is to the right in any text editor, etc. (oddly, Steps Recorder's screen shots show the cursor in the correct position, though it was wrong when the recording was in progress.) Only the arrow pointer where the tip is in the top-left and needs no offset is correct.

I've tried the following:

• Rebooted the computer
  
• Removed the mouse from device manager, then reconnected it on a different USB port
  
• Checked for windows updates, installed, and rebooted
  
• Changed the mouse pointer settings (speed, appearance, DPI, etc.)
  
• Installed the latest drivers for the graphics card and rebooted.
  

With no effect on the issue.

 

Click and drag keeps speeding up on touchpad

Hi,

Do you face this issue while moving the mouse cursor normally on the desktop screen?

If yes, I suggest you to follow the below steps in order to slow down the mouse cursor speed.

• Go to control panel.
• Click on mouse.
• under pointers options tab adjust the pointer speed, click
  apply and ok

let us know the status of the issue to assist you further.

Thank you.