Windows 10: Mouse scrolling broken; "jumps" back up and down

I am using a Windows 11 PCMy mouse scrolling is broken; every few scrolls, it 'jumps' back up or down; I've seen a few people have this problem, and I've tried every solutionhttps://answers.microsoft.com/en-us/windows/forum/all/mouse-wheel-jumps-in-opposite-direction-when/d729255f-93d4-4f44-986d-4963b114e6f2https://answers.microsoft.com/en-us/windows/forum/all/wireless-mouse-scroll-jumps-scrolls-in-reverse-a/5b5db18d-0f4d-4f67-b7db-03c179ff480fhttps://answers.microsoft.com/en-us/windows/forum/windows_7-hardware/mouse-scrolling-down-goes-up-slightly/e1a58d5d-684a-47fc-ad9f-d745a15686ff It'

:)

 

Mouse Scroll Jumps

Hello Nate,

It is possible that the Vertical Scrolling is set to a higher numeric value. To assist you with your concern I would suggest checking the Vertical Scrolling to isolate the issue. Just follow these steps to isolate the issue.

• Press the Windows key and go to Settings.
• Click Devices and go to Mouse.
• Click on Additional mouse options.
• Click on the Wheel tab.
• Put a bullet on Roll the wheel one notch to scroll and change the numeric value to 2 or 3 (Depending on your preference.)
• Click Apply, then OK.

Check if this will resolve the issue.

Let us know how it goes.

Regards.

If you think this was useful, you may "mark it as an answer" to help those who are facing the same problem.

 

USB Wireless Mouse Scroll Jumping

Recently, on Windows 10, when attempting to scroll the page will sometimes jump up, then down when I am scrolling. I am using a new Gear Head Wireless USB mouse, which in the past as worked perfectly well. I have tried solutions previously listed on the
web (cleaning the sensor, turning down the amount of lines that will be scrolled), and so far, nothing has worked. Any advice?

 

jumping page when scrolling with mouse wheel

I am using windows 10 and recently my mouse started jumping the page up and down when using the wheel for scrolling. I have tried changing the settings like suggested but it doesn't work. What else can I do to fix this problem?