Windows 10: Multiple BSODs on startup are preventing fresh install of Windows 10

My laptop was having screen glitching issues a few days ago. I tried updating my graphics drivers, uninstalling recent apps. Nothing worked so I decided to do a clean reset. The reset failed and then I started getting blue screens. I tried to boot up in safe mode but the screen still glitched to the point where it was unusable and even got BSODs in safe mode. I tried running commands like 'sfc /scannow' or 'chkdsk /f /r' in WinRE but nothing changed. Then I tried doing a fresh Windows 10 install using the media creation tool via usb. I attempted this multiple times but it would always blue screen either on startup or during the installation process. I've tried to install Windows 10 on both my SSD and HDD, but neither worked. It successfully installed one time for a few minutes and I was able to run windows memory diagnostic but there were no errors with my RAM. And then the problems returned and I had to start over. I've also switched sticks with another laptop and that laptop ran fine, and I've run memtest86 with no errors. Now I'm at the point where my drives are formatted and basically all I can do with my laptop right now is get to BIOS, sometimes get to WinRE, and sometimes get to the windows installation screen (and then it blue screens soon after). What else can I do about this?

:)

 

Windows 10 installing progs

Fresh installs do it too, in fact i have had the same bs happen. Might be suggested apps which you can turn off.

 

Is it time for Windows 10 already?

Here's a good step by step guide on doing a fresh install.

How to clean install Windows 10 from a USB drive - Software - Feature - HEXUS.net

 

Multiple BSODs in a fresh install of Windows 10


Daemon tools, Alcohol 120% and Power Archiver Pro uses SCSI Pass Through Direct (SPTD), which is a well known cause for BSOD's.
Please remove Daemon Tools and run the SPTD pass through remover.

1. Uninstall Daemon Tools
2. Download the SPTD standalone installer and follow these steps:
   • Double click the executable to open it
   • Click on the button shown below

If the button is grayed out, like in the image, there is no more SPTD installation on your system, and you can close the window