Windows 10: Multiple Bugcheck errors and BSODs with different Stop Codes

Hello,I recently updated Windows 10 for the KB5011259 as well as my BIOS software for my MSI X570-A Pro and my computer went from perfectly fine to pretty much unusable. When I saw errors such as IRQL_NOT_LESS_OR_EQUAL - I went to see if all of my drivers were updated. They were. Windows was also fully updated. I also received errors such as APC_INDEX_MISMATCH, KERNAL_AUTO_BOOST_INVALID_LOCK_RELEASE, KERNAL SECURITY CHECK FAILURE, DPC_WATCHDOG_VIOLATION, SYSTEM_SERVICE_EXCEPTION.To help out with this, I collected the dump files that I could, zipped them, and placed them in the onedrive folder

:)

 

BSOD when coming out of sleep, multiple error codes

Thanks for the assistance, I've run all the necessary steps. It looks like there might be an issue found when running that first command. I have also installed all the driver updates recommended by the dell support check.

You can find the logs of the command prompt window in the cmd.log file

cmd logs.txt

 

BSOD during gaming, plethora of different error codes!

Hello and welcome to TenForums

The log files that you provided only show one crash dump file so there is not a lot of information to go on. Furthermore the bugcheck code is not one I have ever seen before!

The stack recorded in the dump includes some references to storage and the analysis suggests memory corruption and so with nothing else to go on I would suggest that you do a check on the hard disk and RAM. This maybe the same as you have already run but it would be good to see the results.

Try CHKDSK
using option 3
Then



Diagnostics Test [/i] HDD TEST
*Arrow Run HDTune to

• check the health,
• scan for errors, no quick scan but full scan
• run a benchmark.

It may take some time, but please take the time you need to perform it properly.
When above is done please make screenshots of the following

• the health,
• the error scan,
• the benchmark incl. following
  • transfer rate,
  • access time,
  • burst rate,
  • cpu usage.

Similarly with a memory test it would be good to post the results after you have run memtest86+ for a minimum of 8 passes

You indicated that many more crashes have occurred, however, they are not being recorded. Please make sure that your system is setup to record crash dump files: Configure Windows 10 to Create Minidump on BSOD

If the BSOD errors are all different it does tend to suggest a hardware problem. Sorry I can't be more helpful.

 

Constant BSOD with multiple stop codes

I've been getting BSODs for months now when gaming and I can't figure out what's going on. Here's the list of stop codes which I've tried troubleshooting individually with no success:

Page Fault in Nonpaged Area

IRQL Not Less or Equal

Kernel Security Check Failure

APC Index Mismatch

In the Event Viewer I found that I am getting a error for a Bugcheck. Here's the message I receive: The computer has rebooted from a bugcheck. The bugcheck was: 0x0000000a (0xffff9c005ff16354, 0x0000000000000002, 0x0000000000000001, 0xfffff8024f3791f2).
A dump was saved in: C:\WINDOWS\MEMORY.DMP. Report Id: 29aa2753-78f1-403f-9f8b-412131cde536.

I'm not sure how to open the dump file or attach it for anyone to review but any help on this would be appreciated.