Windows 10: my 32 TB SSD has a disk write error, how can I solve it

How can I correct this problem

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

The Disk Is Write Protected - How To Remove Write Protection

Hi Fernanda,

Thank you for writing to Microsoft Community Forums.

In regards to your concern, please help me with following questions:

• Is the Hard drive external or internal?

You can try following steps and check if that fixes the issue:

1. Run Virus scan on the Hard Drive.
2. Perform check disk commands on the Hard Disk to fix the Disk errors.

Refer to this article.

Note: Remove all the external devices before performing check disk.

Data Loss Disclaimer:

While performing these steps there might be a risk of data loss. You may take a backup of the data before performing the steps.

Hope it helps.

Let us know if you got the help you needed by clicking Yes or No.

Rohit Raina

Microsoft Community - Moderator

 

new pc 1tb hdd to ssd clone advice needed

@davnav - if You go the route suggested above of backing up the large drive and restoring to the SSD, make sure you've selected ALL partitions on the source disk for the backup and be aware of the following IF the SSD is smaller than 1 TB:

1) You could shrink your Windows partition of the original disk from within Disk Management so that everything is small enough to fit on the SSD BEFORE making the backup image OR

2) You can resize the Windows partition AS YOU SET UP the restore from Macrium using drag and drop and resizing the partition to fit. Here is a step by step direct from Macrium on doing the resizing I speak of (Kari's tutorial does not cover it), see in particular Steps 5 & 6: https://knowledgebase.macrium.com/di...ion+properties

Of course, much simpler if your SSD is 1 TB and you need not bother with what I write here.