Windows 10: My battery Capacity is designed to be 41,900 but the capacity i can use it is just 2,736 i...

i can do with my dell inspiron 3501 for free pls my battery report is this :-NAME DELL FDRHM09 MANUFACTURER LGC-LGC3.65 SERIAL NUMBER 34285 COMPUTER NAMEDESKTOP-UUHFC7USYSTEM PRODUCT NAMEDell Inc. Inspiron 3501BIOS1.28.0 12/15/2023OS BUILD19041.1.amd64fre.vb_release.191206-1406PLATFORM ROLEMobileCONNECTED STANDBYNot supportedREPORT TIME2024-03-1312:43:28Information about each currently installed batteryBATTERY 1NAMEDELL FDRHM09MANUFACTURERLGC-LGC3.65SERIAL NUMBER34285CHEMISTRYLIONDESIGN CAPACITY41,998 mWhFULL CHARGE CAPACITY2,736 mWhCYCLE COUNT-Power states over the last 3 daysSTART TIMESTATES

:)

 

My Battery Design Capacity Changed?

I have interesting problem.

In the past my laptop battery life was just 1 hour and then I searced why this thing is so low and, I noticed my laptop battery capacity is 24.000mWh.

I did calibration my battery and this amounth decreased 20.000mWh. After that yesterdey my laptop battery increased 29.000mWh.

My real capacity is 60.000 mWh. That`s why windows is using just %50 portion of my battery.

How can I change this amounth?

Current amounths from diagnostic:

Current Battery Value: 17.850mWh

Full Charged Capacity: 29.184 mWh

Designed Capacity: 29.184 mWh

 

Design capacity is equal to full charge capacity in battery report

My battery report is acting very weird... it shows the design capacity equal to that of full charge capacity and both are decreasing over time. Can anyone help?

I use my laptop plugged in most of the time.

every week I drain the battery to 10-15% for its health so I shouldn't be getting this problem.

 

Windows 10 battery report - Full charge capacity exceeds design capacity

I've replaced the battery twice on a Sony Vaio SVS15 with an aftermarket brand and have run into an odd result in Windows 10 battery report.

This shows up and slowly increases(full charge capacity) after following each of the battery manufacturer's recommendation to discharge the battery completely to allow software estimates' re calibration. On initial install, the capacities match.

With the first aftermarket battery:

After fully charging to 100%, then unplugging the charger, the battery will reflect 96% within about a minute. It then seems to discharge much faster than the estimates given by Windows. At the 10% mark, the system shuts down unexpectedly, completely drained.

Second aftermarket battery:

Intermittently, it shows 96% and not charging - I can unplug the charger and back in to bring it to 100%. Upon reaching 10% remaining (10 minutes remaining estimate), it'll run for another couple minutes, then lose power.

Are there other ways to re-calibrate a system to properly report battery life, or could these simply be two faulty batteries?