Windows 10: My computer prompts me to write A1B2C3 - again and again and again

My HP computer prompts me to enter A1B2C3 because I enter to many faulty pincodes wich I did not and never did. Then I am asked to sign in with PIN code which I never previously used and did not know I had. No other option to sign in, nor any option for a forgotten pin code or password. The problem started after only a few months after purchase 23-08-27. For 1 1/2 years I have had no access to the computer bcs of this. I have done nomerous searches online to try to correct it and did everything. Painstachingly followed instructions leading nowhere. I just rebooted the computer but problem st

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

A1B2C3

I’m ready to pull my hair out and throw my laptop out the window! It will not let me type in A1B2C3 and every suggestion takes me right back to it! BTW, I never put in the wrong information to begin with! It was fine one day and this the next! Nothing will let me type it in, change password/pin, not even another screen! Ahhhhhh!

 

The media is write protected on internal HDD

This should or maybe I should say could help with your problem...

Step 1.

From All Programs….select “Windows System”………Right Click and select “Run as Administrator” on “Command Prompt”…….when the cmd prompt window opens go to the next step…

Step 2.
Type "diskpart" at the prompt and press the "Enter" key. The Diskpart tool launches.

Step 3.
Type the "list volume" command, without quotes, then press the "Enter" key. The volumes attached to the computer are listed.

Step 4.
Type "select volume X" (omitting quotes and replacing "X" with the letter of the volume to modify) and then press "Enter."

Step 5.
Type "attributes disk clear readonly" (again omitting quotes) and then press "Enter" to make the specified disk writable.

Step 6.
Type "exit" to close the Diskpart utility.

Hope you get it figured out....