Windows 10: My computer with with Windows 11 Pro won't boot to the blue screen. It just goes to a...

My computer with with Windows 11 Pro won't boot to the blue screen. It just goes to a screen that says "scanning and repairing drive f". It then eventually goes to an all black screen. I can still move the cursor, but that is it. How can I fix this? I've tried shutting it down 3 times to boot in safe mode and it did the same thing.

:)

 

my computer won`t wake up after goes to sleep

these computer won`t wake up after goes to sleep ?

 

Upgrade crashes: It now will not boot into windows at all and just goes into the blue troubleshooting screens

Hi Enger,

I regret the inconvenience you’re facing regarding Windows 10 upgrade, and I appreciate for trying the steps to fix the issue.

To assist you better, I request you to answer the following question:

• 
  Did you receive any error message while upgrading?
  
• 
  “Blue troubleshooting screens” do you refer to the Advance boot options for windows 10?
  

If you are not able to boot to the desktop screen, I suggest you to install the windows 10 using Media creation tool and check if it helps.

I suggest you re-built the boot record by following the below commands so that you can boot to the desktop screen and check if it helps.

You will have to use Windows 10 installation media to follow the steps to boot into Recovery Environment and try to rebuild BCD.

Step 1: I suggest you to create an installation media for
Windows 10 using the media creation tool:

Installing Windows 10 using the media creation tool

Step 2: After preparing the installation media, insert it hard reboot the device and follow the below:

• Boot into Windows Recovery Environment using the Windows 10 installation media.
• Click on Repair your computer.
  
• Click on Troubleshoot and in the Advanced options.
• Select Command Prompt. Type the following commands into the prompt and press Enter key after each command.

• 
  bootrec /fixmbr
  
• 
  bootrec /fixboot
  
• 
  bootrec /scanos
  
• 
  bootrec /rebuildbcd
  

5. Restart the computer.

NOTE: Modifying BIOS/ complementary metal oxide semiconductor (CMOS) settings incorrectly can cause serious problems that may prevent your computer from booting properly. Microsoft cannot guarantee that any problems resulting
from the configuring of BIOS/CMOS settings can be solved. Modifications of the settings are at your own risk.

Hope it helps. Reply to the post with an updated status of this issue for further assistance.

Thank yoou.

 

Computer won't Get Past Boot Screen

Safe mode and run driver sweeper