Windows 10: My computer wont turn on after using blender

So if anyone is familiar with blender this would help. I was using blender and i was watching this tutorial, https://m.youtube.com/watch?v=2pLYyn86qQU. At about 2:34 he said to click the bake button, and without knowing what it was i clicked it. After that my whole computer froze and was about like 1 fps. But i could sort of click through my tabs. After that i had to go back to school, so i then had to do school on my phone. I left thinking that when i got back my computer would be fine but, when i did get back my computer fans were running like usual but the monitor was black. But it still had power bc the light on the monitor indicated that it was just off. I tried turning it on but it said no signal. So eventualy i forced it off and tried to turned it back on and i realised that as soon as i turned it back on it was on full power and usualy it is on low for a few 20 secs or so. So i unplugged the video cable fro my monitor and its power cable and left my computer off for about an hour and a half. I then came back and tried to turn on my computer but it the fans just stayed on low the whole time and the monitor didnt turn on. And then i forced it off again. And thats where i am now. Someone plz help me


Also if this means anything, i followed the whole tutorial up until i hit bake and my computer started freezing

:)

 

My hp laptop wont turn on

This is a frequent problem am sure as you have already seen from online searches.

Flea power is usually the culprit here, basically its residual power that remains on the computer even after thecomputer has been shutdown. You can drain the flea power with the steps the other answers have suggested.

• Disconnecting the battery and adapter
• Press the hardpress the power button for 30 seconds
• This should clear the flea power

If this doesnt work, read this article its about
a dell inspiron but the same applies for you hp. It has some detailed step by step instructions

 

Blender compatibility for windows 10

Hi Sean,

Which version of Blender is installed on the computer?

I see that Blender, version 2 is compatible with Windows 10. To verify, click the following link.

Explore Windows 10 OS, Computers, Apps, & More | Microsoft

If you are using the compatible version, then the issue could be due to some third party services or applications.

Place the computer in clean boot and check if the issue persists. You may follow the article mentioned to perform a clean boot.

A clean boot allows the Windows operating system to launch without any additional programs or services running when you turn the computer on. This allows you to determine if computer issues are caused by a program or service that starts up when you
boot the machine.

Refer: http://support.microsoft.com/kb/929135

Note: After performing the troubleshooting steps, check the section
“how to reset the computer to start normally after clean boot troubleshooting".

Please update us with the status. We will be glad to assist you.

 

Computer wont turn on

I installed a new PSU in my old computer Q6600 setup I had, turned it on it worked I was installing Windows 7, and I leave to go to class while it installs it self and when I get back I can just put in whatever I need to for information serial number etc. I come back and then computer is completely off, tried turning it on and it wont come on, led lights on the motherboard wont turn on etc. What could this be?? im guessing its the PSU, but it could be the motherboard right?