Windows 10: my external hardrive is "write protected" but only on one computer not the other... how can...

i have 2 computers, i was using an external computer to put data onto it to transfer to the other pc. my other pc can read and copy it, but no matter what i do, i cant modify it.in the computer that wont let me modify i have:attempted to formatuse diskpart to remove locktried aomei took it back to my other pc and formatted it, even fresh i cant modify the drivei completely deleted the volume the attampted to make format again on the problem pc.for some reason my second pc will simpply not let me remove the write protection/other usb memory devices let me use them as normal

:)

 

Gettign error "device is write protected" for External Hard drive in Windows 10

Hello Neil,

Thank you for contacting Microsoft Community.

We understand the inconvenience you have experienced.

Are you getting the same error when you access the External Hard drive on another computers?

When you see the message "Device is Write Protected", then it indicates that you have limited set of privileges for performing operation on the Hard disk. In simple, you're not allowed to write the drive, apart from reading it. This because the drive is
write-protected. Suggest you to try with the below steps and check it they help you.

1. Right-click on Start button and select Command Prompt(Admin).

2. Type diskpart and press Enter.

3. Now type list volume and press Enter. Now see the volume number the external drive.

4. Then type select volume #, where # is the number of the drive which is showing "write-protected" error. Example,
select volume 3.

5. Type attributes disk clear readonly and press Enter.

• Executing the above command line will reset the Hard drive USB's properties by clearing the Read-Only behavior, so that it is no longer read-only.

6. Type exit and press Enter. Now check if it allows you do access the drive for writing the content.

Keep us posted if you require further assistance.

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

How to format write protected usb pendrive?

How to format write protected usb pendrive?

tried all stesp from following list, but not sucessful.

Code: http://www.makeuseof.com/tag/how-to-fix-write-protection-errors-on-a-usb-stick/[/quote]