Windows 10: My factory reset is stuck on 2%

I just got my pc from a workshop. And i was stupid enough to use the Acer jumpstart (basically it installs things you dont even want or need on your pc) and then i wanted to factory reset since im gonna sell this pc. And then i did everything correctly, and now ive been on 2% for about 45 min. Help? (I dont need my files backed up since i dont have any)

submitted by /u/Rip_tiger
[link] [comments]

:)

 

Stuck during factory reset.


So the Factory reset has been stuck at 2% for the last 8 hours.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Stuck In Set Up Loop After Factory Reset

Thanks, I can look at that now I'm on a laptop. Here was the screen tapping F11:





and this was the system before restoring it: