Windows 10: My HP laptop is getting off automatically after 30 Seconds

Hi community my HP 1000 laptop is getting off automatically after every 30 seconds when i turn it on the screen remains black. i have changed the RAM, laptop battery and charger but issue remains. I think it is the issue of BIOS. Can anyone help ,e troubleshooting the issueRegards:Laurenshttps://printebill.com/

:)

 

My hp laptop wont turn on

This is a frequent problem am sure as you have already seen from online searches.

Flea power is usually the culprit here, basically its residual power that remains on the computer even after thecomputer has been shutdown. You can drain the flea power with the steps the other answers have suggested.

• Disconnecting the battery and adapter
• Press the hardpress the power button for 30 seconds
• This should clear the flea power

If this doesnt work, read this article its about
a dell inspiron but the same applies for you hp. It has some detailed step by step instructions

 

HP Laptop Boot Loop

I am encountering a boot loop problem with my HP laptop. Upon startup, it shows the HP logo and loading dots for about 11 seconds, then goes to a blank screen for approximately a minute before automatically restarting. The power button does not turn off during this cycle.

Troubleshooting Steps Taken:

• Tried hard reset and accessing BIOS/UEFI settings.
  
• Unable to boot into Safe Mode or recovery environment.
  

please see here the recorded video demonstrating the boot loop behavior for reference.

Any advice, troubleshooting steps, or insights into what might be causing this problem would be greatly appreciated.

Thank you in advance for your help and suggestions.

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.