Windows 10: My Laptop back to factory setting after windows update 20H2

Couple of days before, I updated my windows 10 to 20H2. It prompt me to upgrade bios too in which I opt to no.But sadly in the morning after I turn on the device. All setting are gone, all profiles, all apps, all directory and my files on C drive are vanished too. It was like it did factory reset.I try to restart to check if that was temp profile bug, but that was not the case. I check for Windows.old directory. It has the same content with my current setup.Is there any way I can revert to original state?Is my files, apps, and setting are gone for good?

:)

 

Update 20h2

Hi Wicki,

I am Sumit, an Independent Advisor and a 3 year Windows Insider MVP here to help.

20H2 should not be installed right-away on your device - MS said the rollout is only to a fraction of users and would be labeled as an optional update initially. Are you enrolled in WIP?

You may uninstall 20H2 using the steps below:

https://www.yourwindowsguide.com/2020/10/uninst...

Content on the above blog is written by a Microsoft MVP so it is safe. However, do watch out for the ads.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

HyperSLI (Enabling SLI on non-sli motherboards)

To turn off windows updates in windows 7 follow these steps:

Click the start button, in the search box type in 'windows updates', click on 'windows update'
in the search results list, in the left side of the windows update window click 'change settings'
then in the option bar select 'Never check for updates'.