Windows 10: My laptop isnt rebooting in itself after i factory reset it with cloud installation all...

Hi, I did a factory reset with cloud installation all files removed from all drives It is Windows 11. It started out fine and installed the new version 100 % but then nothing is happening. Normally when I reset my laptop it shuts off and then restarts. But its been 2 hrs but nothing is happening and i am able to use the laptop as if i didn't reset it a while back, everything is same as before. Though my electricity was out for half an hour but it was quite some time after the installation finished. So, the laptop isn't rebooting in itself. What do I do?

:)

 

how do i reset a asus laptop to factory settings?

The process of resetting an Asus laptop to factory settings can vary depending on the model and operating system. However, here are the general steps you can follow:

1. Back up your important files and data to an external hard drive or cloud storage as resetting your laptop to factory settings will erase all data.
   
2. Press the "F9" key repeatedly while the Asus laptop is booting up. This will take you to the recovery menu.
   
3. Select "Restore factory settings" from the menu.
   
4. Follow the prompts to confirm the reset process.
   
5. Wait for the reset process to complete, which may take several minutes.
   
6. Once the reset is complete, your Asus laptop will be restored to its original factory settings.
   

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Ive factory reset my computer but I can't use the mouse or the keyboard to select laugage

Hi,

A device like your keyboard and mouse is not detected during factory reset.
To help us determine the appropriate troubleshooting steps
that can resolve your concern, we would like to ask the following questions:

• Are you performing a factory reset on a laptop or a desktop?
• Is this the first time you perform a factory reset on your device?
• What troubleshooting steps have you done so far to resolve your concern?

In the meantime, if you're working on a desktop, we suggest that you try to use a PS2 keyboard just to bypass the installation process. Once Windows is up and running, you may now plug your mouse and keyboard to initialize Windows to detect these devices.

We look forward to your response.