Windows 10: My pc boots up with the wrong ssd

I built my pc and installed a 1tb ssd and downloaded windows 11 on the 1tb ssd then I bought a 2tb ssd. When I installed the new 2tb ssd I removed the old 1tb ssd and installed windows on the new 2tb then I plug back the old 1tb ssd. I have both on my pc now. I turn on my pc and it boots up and I can use my pc but when I try to go to advance startup it shows recovery with a blue screen error code:0xc0000098Also I tried to boot up with the 2tb ssd but It only shows the 1tb ssd on my bois to choose from I am able to use the 2tb ssd for space I have used it to download files on it I thought my

:)

 

Unable to boot Windows after cloning it to SSD

Hi,



Thank you for writing to Microsoft Community Forums.



I understand that you are facing issues while booting the PC after cloning Windows to new SSD. I would like to know what happens when you try to boot the PC to desktop using SSD?



The reason you are not able to boot the PC is that the files required to boot Windows are still recognizing the HDD as the main drive. I would suggest you to try rebuilding the BCD files and see if you are able to boot the PC using
SSD.



Kindly follow the steps below to rebuild the BCD.

1. Create a bootable media and boot the PC using the media.
2. On the Install Windows screen, select Next >
   Repair your computer.
3. On the System Recovery Options screen, select
   Troubleshoot> Advanced options > Command Prompt.
4. Now type in the commands and hit enter: BOOTREC /FIXMBR
   
   BOOTREC /FIXBOOT
   
   BOOTREC /scanos
   
   BOOTREC /rebuildbcd
5. Restart the PC.

If the issue persists, please get back to us with the results of the troubleshooting steps to assist you further.



Regards,

Prakhar Khare

Microsoft Community – Moderator

 

Automatic repair while booting from hdd and installing windows on ssd.

1. Migrated windows from hdd to ssd
   
2. Formatted hdd
   
3. Prioritised boot from ssd in bios
   
4. Turned on the pc
   
5. Automatic repair
   

To deal with this I select boot from a device > then EFI USB device > it says no bootable USB detected, select from these drives > there are few options including the newly installed ssd > I select ssd > then it shows disk checking, press any key to stop > I stop it > windows then boots from ssd.

It very difficult to repeat all this everytime I turn on my pc. Please suggest a fix.

 

PC Build Steps

1.1 - Ideally put optical in SATA 0, and SSD in SATA 1, this will cause the optical drive to be the default 1st boot option. You can change it manually if not, but I like it this way
2.infinity - yes, that's fine. if it's above 70 +/- 5 degrees, then it may just need a repaste/remount