Windows 10: My PC can't boot to Windows

My PC can't boot to Windows , until i press any key for a few second. Some solutions I tried failed like this:1. Fix Mbr, Boot and Rebuild BCD in CMD Advanced Option2. Re-installl Windows3. ...Who can help me? Any Support is welcomed.

:)

 

Boot Process

Hi,

Please suggest me a link that can explain the boot process step by step of ...

• Windows 7,
• Windows 8.1,
• Windows 10,
• Windows Server 2008 R2 and
• Windows Server 2012 R2

With Regards

InTech

 

Sabertooth 990fx won't boot to windows logo, it shuts down

to boot and enter bios and load windows, any todays PSU (with the correct plugs) will work, AFAIK

to enter BIOS only low wattage is used.
Then, during boot, the HDD and a bit later the videocard card start to demand juice, then the other devices and periphericals... so the total demand during boot up is incrementing step by step, that's why a failure halfway could indicate a PSU problem....

 

How does Windows boot to advanced recovery option e.g. command prompt?

- that gives me a 454 'Unexpected error' This tells me that the BCD is partially corrupted.

The commands: shutdown.exe /r /o /f /t 00
or: %SystemRoot%\System32\Cmd.exe /c reagentc /boottore&shutdown /r /f /t 00
should boot into Recovery if everything is configured correctly.
FYI, If Windows is configured correctly:

1. If Reagentc is disabled, you still can get into Recovery but with limited options.
2. If Reagentc is enabled, you'll get all options.
3. If you boot Windows using Recovery USB stick, You'll get into Recovery with couple of options missing.

Here's my suggestion if you want to try:
OPTION 1: Will save the trouble of re-install Windows.

1. Download the image of my first 3 partitions (450MB Recovery, 100 MB EFI partition, and 16MB unformatted primary)
   EFI_Boot-00-00.7z - Google Drive
2. Run Macrium and restore the image from step 1, overwriting your existing 1st three partitions, leaving C alone.
3. Delete the 490MB Recovery partition.
4. From Macrium, run fix boot problems.
5. Reboot. Open Admin command prompt then run Reagentc /info to make sure that it is enabled. If not, enable it.
   if failed to enable, reboot and try again.

OPTION 2: Assuming you've already had Windows backup with Macrium.

1. Wipe out the first 5 parttiions. (450MB, 100MB, 16MB, C Drive, 480MB)
2. Fresh install Windows 10
3. Restore C drive from backup image, run fix boot problems
4. repeat step 5 from OPTION 1 above.