Windows 10: My pc isn’t coming up after it went off on power saving mode what do I do

I was working on system and it went on power saving mode I forgot to plug in immediately and the PC went off by itself.. Then I plugged in the charger, it shows charging but not coming up.. Doubled checked charger with another pc and it’s working but my system is still not coming up

:)

 

Problem with the power saving mode

Hello,

I've had a problem with power conservation for a few weeks now. Normally my procedure is the following:

1. Putting the PC into power saving mode
2. Switch off the connector strip to which the PC is connected
3. Next time switch on the power strip and start the PC

Windows Version: 2004, Build: 19041.264

Before that, all the programs I had open before power saving mode were open. Now I have the problem since a few weeks that the PC boots normally and all programs are closed. This is not so nice, because I always have relatively many programs open, so I always have to restart them, which takes some time.
Does anyone know by chance what this could be due to?

Greeting

 

Printer isn´t working after latest update.

After the latest update from Windows, my Canon Pixma ip6600 printer isnt working. In Device Manager it shows up as working properly but when I go to print it isn´t listed as an option in any programs. Troubleshoot suggests it´s a USB 2 printer on a USB
3 port and that that´s the problem but that cant be since it worked fine before the update. I´ve tried to uninstall and plug it back in but that doesn´t work either.

 

power saving mode after a few minutes on gaming

My friend had a similar problem on his older desktop. if its similar it is a problem with your graphics card overheating or dying. two steps to take would be to open the computer and clean the graphics card cooler thoroughly. And second of all get a friends graphics card and try his in your computer. this will rule out completely any problems with your graphics card. Which i think it is.

Btw. its not your pc outputting "power saving mode". but instead its the monitor saying power saving mode since your graphics card is crashing and the screen is not recieving a signal and going to standby.