Windows 10: My pc restarts automatically after showing this for a few seconds

As it restarts automatically. I can't complete the shift + f10 method. After writing regedit and browsing to to setup or status it just turns off

:)

 

Automatic Restart

We appreciate your response. We suggest that you turn on the automatic restart using command prompt. However, you need to access the
Startup settings. On some Windows 10 computer, pressing
F11 once a computer boots up will bring the System Recovery menu. We suggest that you check if it's the same on your computer. Here are the steps on how to do so:

• Turn on your computer, then press F11 simultaneously.
• If a blue screen with Choose an option shows up, click on
  Troubleshoot.
• Look for Advanced options, then click on Command Prompt.
• On the command prompt, type this in "wmic RecoverOS set AutoReboot = True".
• Once done, click the "X" at the top right of the screen.

Restart your computer and see if the issue persists.

We would appreciate it if you'd provide a screenshot of the command prompt.

We're looking forward to your feedback.

 

PC shows Automatic Repair screen after booting

Hi,

Thank you for replying.

Refer the steps mentioned below to restart the computer in Safe Mode:

1. On the Choose an option screen, click on Troubleshoot.
2. Click on Advanced options.
3. Click on StartupSettings and click on
   Restart.
4. After the device restarts, you will see list of options. Select option
   5 or press F5 to boot the computer into
   Safe Mode with Networking.
   

After restarting the computer in Safe mode, refer the steps mentioned in my earlier response to perform clean boot and see if the PC boots normally.

If the computer doesn't boot,
I would also suggest you to refer the troubleshooting steps mentioned in the section
Use installation media to restore your PC from the article
Recovery options in Windows 10.

Let us know how it goes.

Regards,

Nikhar Khare

Microsoft Community - Moderator

 

Automated Restart of Windows 10 PC

Hello,

If Windows suddenly restarts without warning, or restarts when you try to shut it down, it might be caused by one of several issues. An outdated driver and software conflict are some of the possible reasons. Having said that, we suggest performing
the following steps:

Step 1: Disabling the automatic restart option to view error messages.

Many hardware driver or operating system errors will cause the computer to display a specific error message before stopping the operation or shutting down the computer. However, if the Automatically restart option
is enabled, an error message might not be displayed despite an error taking place. Disable this option to allow the computer to display the error message.
Follow these steps to disable the Automatically restart option:

• 
  In Windows, search for and open View advanced system settings.
  
• 
  Click Settings in the Startup and Recovery section.
  
• Remove the check mark next to Automatically restart under System Failure, then click OK.
• Restart the computer.

Step 2: Checking for failed hardware.

Hardware problems can cause the computer to restart unexpectedly.

Let us know if that worked out for you.